ESP32-C6 Blink Quick Start Case

This document serves as the case showcase entry from the project overview. Complete wiring, configuration, flashing screenshots and troubleshooting steps will be added later.

Case Overview

This case targets the ESP32-C6 development board, with the goal of completing firmware flashing and verifying the onboard LED blink, helping new devices quickly confirm the development environment, serial port access and basic GPIO output capability.

Planned Content

• Supported board models and firmware versions
• Online flashing and local programming steps
• LED pin and configuration item description
• Runtime status screenshots after platform access
• Common flashing failure and serial port conflict troubleshooting

Temporary Verification Steps

1. Select the ESP32-C6 corresponding firmware or PlatformIO environment.
2. Connect the development board and confirm the serial port number.
3. Flash firmware and restart the device.
4. Observe LED blinking and serial console startup logs.
5. Confirm device online status on the platform.